Snow Performance Stg 3 Boost Cooler EFI 2D MAP Prog- Water Injection Kit SS Braided Line & 4AN

The Snow Performance Stage 3 Boost Cooler? brings true 2D mapped water-methanol injection delivery to your EFI (electronic fuel injected) and forced induction (turbocharged/supercharged) vehicle. The Stage 3 creates a 2D injection map based off boost and fuel injector pulse width to deliver a extremely accurate amount of water-methanol when the engine needs it most. Bringing fuel injector pulse width into the mix allows the injection curve to be extended past specific boost points for greater range/control. None invasive, the Stage 3 Boost Cooler? controller is designed to mount on the steering column or the dash so no additional gauge pods need to be purchased and functions as a boost gauge, water-meth controller and fuel system monitor all in one! Proven to reduce the air inlet temperature by up to 100 degrees and increase octane by 25 points for maximum HP and cooling . Comes with adjustable Stage 3 water-meth controller, 4AN fittings, and stainless steel braided line to mount pump/tank in engine bay of vehicle. For trunk mount options see Part# SNO-40014-BRD, SNO-40012-BRD.

Kit Contents: 300 PSI UHO Pump, 3Qt Tank, Adjustable Progressive 2D Mapped Stage 3 Controller, (1) 1', (1) 2', (1) 5' Stainless Steel Braided Line, Boost Line/Required Hardware, Required 4AN Fittings, SP Decal, Self Sealing Level Sensor, LED Alert System, Snow Performa

Stage 3 Boost Cooler EFI 2D MAP Progressive Water-Methanol Injection Kit (Stainless Steel Braided Line, 4AN Fittings)

Snow Performance Stg 3 Boost Cooler EFI 2D MAP Prog. Water Injection Kit (SS Braided Line & 4AN)

Stage 3 Boost Cooler EFI 2D MAP Progressive Water-Methanol Injection Kit (Stainl

All Forced Induction Gasoline Engines

Nitrous Oxide Injection System Kit

Snow Stage 3 Boost Cooler

Stage 3 Boost Cooler