Today we are in part 2 of our FIC 1650cc Injector series. In part one we did an unboxing video. In part two we will show how to install these FIC 1650s, or any fuel injector in a 3000GT or Dodge Stealth.
This video may also be helpful for those wanting to replace the spark plugs or wires on a 3/S or even to run a compression check. One of the major steps is removing the intake plenum, which is common to many 3000GT maintenance procedures.
For this process you will need approximately the following tools:
- 3/8 Drive Ratchet
- 3/8 Drive torque wrench would be nice to have, plenum bolts are 13 ft/lbs.
- 10mm Socket
- 11mm Socket
- 12mm Socket
- 13mm Socket if you have any aftermarket bolts.
- Allen sockets if you have any allen bolts.
- A small quantity of motor oil
- Clean shop rags
We hope you enjoy our video!
Injector Battery Offset / Latency Settings for the AEM EMS Series 2
For help on setting injector battery offset please view this Battery Offset Guide